Introduction to the Principle of Burner Ignition Transformer

The main functions of the transformer are voltage transformation, impedance transformation, isolation and voltage regulation, etc. Transformers are widely used in burner automation control, and there

Read

Common Faults and Troubleshooting Methods of 530SE Controller of Riello Burner

one. Conditions necessary for repairing 530SE controller: 1. One small power regulator; 2. One 530SE controller base;

Read

Safety valve selection method and related knowledge

The safe discharge capacity of a pressure vessel refers to the amount of gas that must be released per unit time in order to ensure that the pressure of the pressure vessel does not rise again when th

Read

Working principle of gas solenoid valve

Solenoid valve is an automatic basic component used to control the direction of fluid, which belongs to actuator; it is usually used on mechanical control and industrial valves to control the directio

Read

Influence of Burner Position and Flame Shape on Calcination in Precalciner Kiln

The shape of the flame is determined by four concepts: width, length, narrowness and shortness. When designing the pillard burner in our factory, the manufacturer designs the best flame shape accordin

Read

Gas fired kiln burner technology

The burner is a key part of the gas-fired lime kiln, and the burner of the gas-fired lime kiln is different from the burner of the ordinary heating furnace kiln

Read

Combination points of burner and boiler

If a fully automatic oil (gas) burner with good performance is installed on a boiler, does it still have the same good combustion performance?

Read

Flame Adjustment of Combustion System of Asphalt Mixer

In asphalt mixers, the combustion equipment for drying aggregates generally uses mature products. Whether the heavy oil burns completely in the drying cylinder has a lot to do with the adjustment of t

Read

Reasonable selection, maintenance and energy saving of burners in asphalt mixing

The development of automatic control burners has been serialized such as light oil machines, heavy oil machines, gas machines, and oil-gas dual-purpose machines. Reasonable selection and maintenance o

Read

Introduction of gas pressure regulating valve and pressure reducing valve

Gas pressure reducing valve, also known as gas pressure regulator, is called liquefied petroleum gas pressure reducing valve if it is dedicated to the pressure reduction of liquefied petroleum gas. It

Read

Industrial gas burner (burner) safety operating procedures

For the newly installed furnace body, carefully check whether the gas meets the requirements of the burner before commissioning; check whether the detection equipment on the gas supply pipeline is nor

Read

Classification and working principle of solenoid valve

Looking back at the development history of solenoid valves, so far, solenoid valves at home and abroad are divided into three categories in principle (ie: direct-acting, step-by-step direct-acting, pi

Read

Basic introduction of gas pressure regulating valve

Gas pressure reducing valve, also known as gas pressure regulator, is called liquefied petroleum gas pressure reducing valve if it is dedicated to the pressure reduction of liquefied petroleum gas.

Read

Fully automatic proportional adjustment of fuel and air ratio burner

Fully automatic ratio adjustment of fuel to air ratio: saving money and benefiting the environment

Read

Structural characteristics and application effect introduction of hydrogen burne

The hydrogen burner is a common name for the combustion device used in industrial fuel furnaces, which can be understood as the abbreviation of "burning nozzle". Usually refers to the body part of the

Read