There are many types of fuel for boilers, such as common coal-fired boilers, gas-fired boilers, oil-fired boilers, electric boilers, etc. However, with the environmental protection and economic conditions, most of the gas-fired boilers are used in the market now. When it comes to gas boilers, it is necessary to improve the burners of gas boilers. Boiler House has collected some knowledge about the safe operation process of gas boiler burners, and will share and discuss with you.
1. There are three aspects to the inspection before the commissioning of the gas boiler burner burner:
1. Check whether the gas is in place, whether the gas pipeline is clean and smooth, and whether the valve has been opened.
2. Whether there is any pipeline leakage, and whether the pipeline installation is reasonable.
3. Exhaust air from the pipeline in front of the gas valve to ensure that there is no mixed air in the pipeline, and the exhaust pipe should be connected to the outside.
2. Internal inspection of gas boiler burner burner:
1. Whether the combustion head of the burner is installed and adjusted properly.
2. Whether the direction of motor rotation is correct.
3. Whether the external circuit connection meets the requirements.
4. According to the circuit conditions, simulate the burner in a cold state, and observe whether the various components of the equipment in operation are normal and whether the flame detection and protection part is normal.
3. Debugging of gas boiler burner burner:
1. Check whether the external gas is in place, whether the pipeline is unobstructed, and whether the external power supply is in place.
2. Adjust the load of the burner to a small load, adjust the ignition position to a small load accordingly, turn off the large load to ignite and observe the flame situation, and adjust the servo motor or damper opening according to the flame situation to achieve a suitable combustion state.
3. Gradually increase the load, and adjust the opening of the servo motor or damper point by point according to the flame situation to achieve a suitable combustion state.
There are many types of fuel for boilers, such as common coal-fired boilers, gas-fired boilers, oil-fired boilers, electric boilers, etc. However, with the environmental protection and economic conditions, most of the gas-fired boilers are used in the market now. When it comes to gas boilers, it is necessary to improve the burners of gas boilers. Boiler House has collected some knowledge about the safe operation process of gas boiler burners, and will share and discuss with you.
1. There are three aspects to the inspection before the commissioning of the gas boiler burner burner:
1. Check whether the gas is in place, whether the gas pipeline is clean and smooth, and whether the valve has been opened.
2. Whether there is any pipeline leakage, and whether the pipeline installation is reasonable.
3. Exhaust air from the pipeline in front of the gas valve to ensure that there is no mixed air in the pipeline, and the exhaust pipe should be connected to the outside.
2. Internal inspection of gas boiler burner burner:
1. Whether the combustion head of the burner is installed and adjusted properly.
2. Whether the direction of motor rotation is correct.
3. Whether the external circuit connection meets the requirements.
4. According to the circuit conditions, simulate the burner in a cold state, and observe whether the various components of the equipment in operation are normal and whether the flame detection and protection part is normal.
3. Debugging of gas boiler burner burner:
1. Check whether the external gas is in place, whether the pipeline is unobstructed, and whether the external power supply is in place.
2. Adjust the load of the burner to a small load, adjust the ignition position to a small load accordingly, turn off the large load to ignite and observe the flame situation, and adjust the servo motor or damper opening according to the flame situation to achieve a suitable combustion state.
3. Gradually increase the load, and adjust the opening of the servo motor or damper point by point according to the flame situation to achieve a suitable combustion state.