The flame detector function tester, also known as a photosensitive fire detector
Blower damper damper, primary air inlet damper, air preheating damper damper, flue gas recirculation, bypass damper damper
Use three-band infrared flame detectors outdoors in petrochemical projects, and use dual-band infrared flame detectors indoors.
In boiler renovation, most companies only pay attention to the choice of boilers, but often ignore the important part of burners and burner accessories.
When the burner is burning during normal operation, if the fire suddenly goes out, it is a flameout failure.
The casing is produced from impact-resistant, heat-resistant plastic.
All filters protect engine parts, have a cleaning effect, and extend the service life of the engine.
Taking the proportional gas burner as an example, its working process has four stages: preparation stage, pre-purge stage
The function of the burner air supply system is to deliver air with a certain wind speed and volume into the combustion chamber.
Burners are also called burners. According to the fuel type, they can be divided into oil burners and gas burners. Light oil burners refer to oil burners.
The burner is fully automatic and does not require human command set monitoring. To avoid malfunctions, please pay attention to the following matters:
Instructions for use of low-nitrogen burner: After pre-blowing air for 13 seconds, the oil pump solenoid valve automatically opens,
As the country attaches increasing importance to environmental protection, cities have imposed strict restrictions on the discharge of waste gas and waste water.
If the burner fails to ignite, the controller automatically shuts down for protection. The fault light (red) lights up.
